Search models, users, collections, and posts
Mushroom nutcracker
IP Report
Print Profile(2)
0.2mm layer, 4 walls, 30% infill, supports, AMS
Designer
6.9 h
2 plates
0.2mm layer, 4 walls, 30% infill, no ams
Designer
3.7 h
2 plates
Open in Bambu Studio
Boost
105
184
16
8
121
80
Released
Description
Here a little nutcracker which looks like a cute mushroom.
It can be a nice decoration in the kitchen, but not only : it really cracks the nuts very easily.
Printing : if you use provided profile, it will work without any issue, tested on P1S.
Assembly:
- assemble the hat and the screw. Normally you don't need any glue, press it strongly to assemble.
- then you will have to screw/unscrew the whole thread between 5 and 10 times to make it smooth to use.
You're ready to crack nuts and almonds !
Consider boosting if you think it is nice !
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)