Oral-B Toothbrush Head Stand and Cover - Two Heads
Copyright Claim
Oral-B Toothbrush Head Stand and Cover - Two Heads
Boost
8
20
9
Print Profile(1)
0.16mm layer, 3 walls, 35% infill
Designer
4.3 h
1 plate
Open in Bambu Studio
Boost
8
20
9
0
38
31
Released
Description
The purpose of this model is to hold 2 brush heads of an Oral-B toothbrush. It has a cover that will print with it, with the purpose of blocking them from getting sprayed with hairspray or any types of power, there are vent holes in the back of the cover that should match the same pattern that is on the stand.
I recommend using the brim with the cover since mine was curling the edges up while printing, the edges have a 0.5mm chamfer, same with the stand if it ends up curling for you.
Comment & Rating (9)
All
Works fine, easy to print
The designer has replied
1
Reply
Awesome! Thank you a lot for sharing the print.
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
The brushes are not fixed/ they slip to
easy from the stand and the stand is way to big for just two brushes.
1
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
The designer has replied
0
Reply
Thanks for leaving a review! Could I know why you took off a star so I could do my best to fix the issue?
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld