Search models, users, collections, and posts
Elden Ring Hookclaws
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
3.9 h
4 plates
Open in Bambu Studio
Boost
24
40
0
0
9
3
Released
Bill of Materials
Description
This is an attempt at modeling the hookclaws weapon from Elden Ring.
Hardware needed per claw (you will need 2x for the set)
3x - M5 Nut
2x - M5x110mm Bolt (for mounting blades to top)
1x - M5x95mm or M5x100mm Bolt (for mounting handle)
You should be able to find M5 nuts at any local hardware store. The bolts you will probably have to find online somewhere. I got the M5x110mm from Amazon and the M5x95mm from McMaster-Carr. M5x100mm should be easier to find and probably fits a little better, the M5x95mm are almost too short it barely reaches the nut.
I used the Blue Gray filament for the blades and the Bronze filament for the handle. Wood PLA might look nice for the handles as well.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)