Fantastic model! This is quite possibly one of the best multi-color prints I have done to date. The supports were a little difficult to get off in a couple places but they did a great job. The color transitions are seamless. My niece is going to love it too. Thank you!
Overall very good, has a small issue with the right hand, the one under the sleeve - appears no support was generated for it. Rest of the model was perfect.
sorry for the bad pics, my phone isn’t picking up the computer screen very well. But I did check the profile for supports. I clicked “open in bambu studio” and then clicked “slice”. there is supports there for the right hand. not sure if yours glitched or maybe one of the support nodes failed.
Awesome! I’m glad you guys like it. yea there is a bit of flushed waste but without anything to flush into, it’s unavoidable.
You can always open it in bambu studio and add a few fidget toys to the plate to flush into to lessen the waste amount.
I think I’m going to design some fidget toys to start adding to my plates to help reduce waste.