Search models, users, collections, and posts
Space Invaders Drawstring beads
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
1.1 h
2 plates
Open in Bambu Studio
Boost
163
372
12
2
114
66
Released
Description
- Comes with a T-bar to remove the supports.
- The hole is 5 mm, so it should fit most drawstrings. The easiest way to put them on is to twist the model while pushing the drawstring down.
- Only 3 grams per set.
- Supports are needed only on two of the models.
- Infill: 15–20%.
- PLA
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)