Incense holder (paw)
Incense holder (paw)
Boost
18
20
5
Print Profile(1)
0.2mm layer, 3 walls, 15% infill, arachne
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
18
20
5
0
36
35
Released
Description
Incense holder yin yang paw.
my incenses are 1.5mm, size them up for larger incenses
in the photo I added epoxy resin with glitter
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 15% infill, arachne
fatto bene magari foro porta incenso un pochino più largo
The designer has replied
1
Reply
si infatti nella descrizione consiglio d ingrandirlo un po,
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill, arachne
I wish they had a hole in the bottom so we could stack them, but I've made a organizer for it I'm gonna share later.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill, arachne
Center hole is not big enough for the incense stick. other than that it printed nicely
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill, arachne
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld