P1P/S PTFE Tube Clip by teh_chaosjester

teh_chaosjester

3D Printer>3D Printer Parts

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 5 walls, 15% infill

Designer

14 min

1 plate

4.3(27)

Boost

243

148

Released

Description

I found that a lot of the other similar clips moved around on the cable chain so I made these with a bit more room for the cable to move around but still stay in the clip.

I've been running these in my P1S (P1P with upgrade kit) for weeks and have had no issues with them moving around.

Recommend printing in PETG with 4 wall loops. That will create a solid part.

!!! New version here Bambu Labs P1P/S X1C cable chain clip for PTFE Tube by teh_chaosjester - MakerWorld !!!

Comment & Rating (41)

@saragin14

Print Profile

0.25mm - Set of 4

Perfetto monta alla perfezione

@arnelenz1986

Print Profile

0.2mm layer, 5 walls, 15% infill

thanks for the profile

The designer has replied

@teh_chaosjester

Thanks for the rating, I am about to test a new design which might fit a bit better.

@teh_chaosjester

New version here https://makerworld.com/en/models/136524, would love to get your feedback on the redesign.

@RickC.

Print Profile

0.2mm layer, 5 walls, 15% infill

Fit nice and snug on the factory chain.

The designer has replied

@teh_chaosjester

Thanks for the rating, I am about to test a new design which might fit a bit better.

@teh_chaosjester

New version here https://makerworld.com/en/models/136524, would love to get your feedback on the redesign.

@QiolaIokasta

Print Profile

0.2mm layer, 5 walls, 15% infill

a bit to much tension on the part after mountig. but works so far

The designer has replied

@teh_chaosjester

Thanks for the feedback, planning on doing a bit of a redesign so the split that attaches to the cable chain is on the bottom so the whole thing sits a bit more flush.

@teh_chaosjester

New version here https://makerworld.com/en/models/136524, would love to get your feedback on the redesign.

@markurian

Print Profile

0.2mm layer, 5 walls, 15% infill

Very handly little clips. I printed these in PC-PETG for both temperature resistance and flexibility.

Other Issues:Looks like the design is a bit small. I did think it could be shrinkage, however measuring the larger clip opening size, it's 14.5mm, and the cable chain is 15mm, thus the clips don't hold on as well as I believe they should, with the bottom part of the clip levering away when fitted. Perhaps a slight re-scale would fix it.

The designer has replied

@teh_chaosjester

Thanks for the feedback, have a redesigned version here https://makerworld.com/en/models/136524 which addresses that.