I like the Model itself, and the Print came out good. Despite Bambu says my last print was cancelled, which is not true.
It is a horrible work to get the supports off behind the swords. Take your time to do this or you might end up breaking them.
There are some floating regions under the feet and under/at the base. That is not necessary and from my point of view should be "fixed". Also the Swords, maybe there is a way to prevent supports behind them by attach them different.
This model looks great with the AMS painting, the colors are spot on. It obviously does take a while to print and waste is high with the color changes, so I printed 3 at once. My only complaint is how much of a pain taking the supports off are around the swords on the back. I've only taken the time to fully take off the supports of one and now one of the swords is hanging on by a thread. As long as you're careful, this model looks great!
Printed with an A1 using Bambu Lab Matte PLA for the Red and Black, the white is some really old Amazon Basics PLA. Total time with timelapse (smooth mode) enabled was 17hrs.
First off, I like the way this turned out. I have been wanting to print this since it was uploaded. It is not without it's flaws , but this was a print for me and I'm satisfied. Removing the supports was challenging around the swords, maybe there is a better support setting someone knows of?
Unable to rate since I run in LAN mode, but it's not ready to print from the 3mf and there are some issues as described by others with the base and feet that should be addressed. The uploader did a nice job coloring the model! A 4 star rating seems appropriate.
You will need supports and is set to grid infill. I set to gyroid and tree supports at the default setting and a threshold of 30. I also enabled Support Critical Regions only and deselected remove small overhangs. This may not be ideal but I had tried printing this a few times with some lesser settings and with little success.