kitchen sink waste food catcher
Copyright Claim
kitchen sink waste food catcher
Boost
69
157
12
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
0.16mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Boost
69
157
12
1
174
86
Released
Description
A little drop in waste catcher for UK 11/2" deep kitchen sink waste outlets. Perfect for catching small to large food particles and then easily pulling the catcher out to put the rubbish in the bin with out getting your hands dirty.
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed perfect but after a couple weeks I broke the handle off so I made one out of TPU with out the handle !!!
https://makerworld.com/en/models/481023#profileId-392680
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very useful. Printed in PLA and No Problems with hot water. I cutted the knob to keep it like the original one
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works well with abs
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed perfectly on BL P1S with 0.4 Nozzle & MatterHackers ABS.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
really like the design. catches a lot of food well but lets water pass through and don’t have to worry about inadvertently blocking the sink
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld