Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
5.9 h
2 plates
Boost
10
16
7
0
34
31
Released
Description
Das Dach und die Basis lassen sich nach dem Aufbringen von etwas Kleber zusammenstecken. An der Lasche des Dachs lässt sich das Häuschen aufhängen.
Modelliert in OnShape: https://cad.onshape.com/documents/ebc9266dadac10b86df16ac1/w/ed3caa76bac1ae3ac1d89b26/e/046518bd1fc5f1573d72add3
Comment & Rating (7)
All
Print Profile
0.2mm layer, 3 walls, 25% infill
The designer has replied
0
Reply
Thank you for your feedback! Can you tell me what went wrong on this print profile for you?
0
Reply
Replying to @CTeipen
I've deleted that file but the top had awful layer lines on it. So much that I ran my Carbon through all of it's calibrations just to see if something was wrong but nothing else prints that way.
0
Reply
Replying to @usmcvet.mark
Im sorry hearing that from you. I will keep this in mind and check on it. Thank you!
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
wie beschrieben gelaufen
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld