New year rattle
Copyright Claim
New year rattle
Boost
3
3
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
3
3
3
1
13
13
Released
Comment & Rating (3)
All
tolerances were a little tight and the rod broke along the layer lines. might try a horizontal print for the handle
The designer has replied
0
Reply
Hi Brandon, i also had to open a little bit the holes, but about thr rod i have no issues, i also have to say that i printed in ABS
0
Reply
Thank´s for the advice... I printed in ABS and everything was fine...
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld