Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
5.2 h
2 plates
Open in Bambu Studio
Boost
18
60
2
0
29
13
Released
Description
I made this for a friend, and might as well share it for you all too!
I initially made it very simple, just a .25" shaft. But that tended to get very wobbly during the last few dozen layers. So I added some ribs for rigidity, and ended up liking it better too.
The cup is sized the same as several candlesticks I measured, seems to be a standard size. It's .875" (22.2mm) at the top, 1" deep and narrows to .75" (19mm) at the bottom.
I printed several of both sizes in PLA, they all came out very clean. I used .16 layer height, of course you can adjust as you see fit.
Note, in one picture you'll see some fuzz on the short one, that's due to random seam placement. I recommend aligned seams on these.
Enjoy! Thanks for checking it out
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)