A1 series nozzle 喷嘴收纳盒 by bestseries

bestseries

3D Printer>3D Printer Accessories

Print Profile(5)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

2.5 h

2 plates

4.9(25)

no pin，only using printer filament 不用插销，使用耗材丝固定

Designer

2.5 h

2 plates

4.8(5)

0.2mm layer, 2 walls, 15% infill

10 min

1 plate

4.8(4)

2 Colors only Fast Printing - 0.2mm layer, 2 walls, 10% infill

2.4 h

1 plate

5.0(1)

Click to see more

Boost

144

458

339

Released

Description

1、A1系列喷嘴收纳盒

2、可收纳三枚喷嘴

3、需要自备直径2mm长度15mm的插销（也可以使用耗材丝）

4、2mm钻头辅助扩孔方便安装

nozzle box

a1mini

box

Comment & Rating (38)

@polymorpher

Print Profile

no pin，only using printer filament 不用插销，使用耗材丝固定

I like it, good fit of the different components. I put some negative cylinders in the slicer to make space for the filament tips as you can see in the picture.I don't think the creation level is high enough to create a remix for this.

The designer has replied

@bestseries

Thank you for your comment. I did not reserve space for the filament when designing because if I did not cut it off, it would be more troublesome to replace the printing nozzle. Therefore, I did not take into account the space for the filament. Your handling method is also a good one, thank you for sharing!

@user_2479191613

Print Profile

no pin，only using printer filament 不用插销，使用耗材丝固定

that was simple as it should

(Edited)

@hendu72

Excellent design! the box snaps shut tight and the insert fits the nozzles great after clipping off the extra filament.

@sgenos

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

My nozzles are tidy

@stemaluti

Print Profile

0.2mm layer, 3 walls, 15% infill

Changed my Printing Settings to Same Color Inlay to print faster - because it was for me, not important.

@o.vonhofe

Print Profile

0.2mm layer, 3 walls, 15% infill

Looks very good, used my own pin for the joints. Maybe it would be a good idea to change the Inner life of the box a little, cause there is always a little bit of filament sticking out of the topside after prints are finished. So the nozzle isnt fitting perfect in the box, if you dont cut the rest of filament on the top.