Search models, users, collections, and posts
Plier stand
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.2 h
3 plates
Open in Bambu Studio
Boost
22
52
6
3
54
40
Released
Description
Wanted a plier stand next to my printer and found one on Thingiverse. Added covers and fitting bars as I did not have wooden ones like the original. Bars are still a bit loose so you can use some glue to make them stick to the cover.
The covers are a bit bigger than the stand so I used some foam strip underneath to make it fit. Did not use any glue for this, foam strip works fine for this.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)