Bed Sweeper

simple bed sweeper to remove prints from the bed once they are cooled. this prevents fingers from accidently touching the build plate, especially with many small prints. the orientation i have the objects placed in the 3MF is the correct way to print. no supports. 
i also added velcro under mine so that its kinda soft like felt or a brush, rather than just plastic. but if ur using PEI plates, i would imagine the bare plastic would do absolutely no harm to it at all. 

assembly:

i have a 0.2mm clearance. it should just simply snap into place. not too tight. certainly not too loose. no glue required on my end.