Chubby korok from The Legend of Zelda
Copyright Claim
Chubby korok from The Legend of Zelda
Boost
51
89
12
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
49 min
1 plate
Boost
51
89
12
2
88
60
Released
Description
This is a cute chubby Korok from the legend of zelda. It has copyright so do not sell it and just use for yourself. It is cute and adorable. Put it somewhere where it can stand if you wish as its so chubby to be in his little legs.
Comment & Rating (12)
All
The print didn't have a big enough brim and it was missing supports where they needed them. 😕
(Edited)
The designer has replied
0
Reply
Recheck your settings and try again. There should not be a problem with the file shared here as it's the one I used. Make sure you printed in the same position it appears in the picture, lying down. If you have any question more let me know
0
Reply
ok
0
Reply
I printed this like 2 times and there were parts that were messed up idk if this Is from my printer or an error from the file
The designer has replied
0
Reply
I think this is your printer. Many users printed it without problems
0
Reply
oh ok, I just got my printer so I've never cleaned it, I think if I clean it it might worl
0
Reply
Boosted
Super cute!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it did not even go to like layer 10 with out peice coming off the build plate, it needs more support in better places
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
tricky print but good design
0
Reply
unfinished parts but good. 👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld