Harry Potter coaster collection by Hába97

Hába97

Art>2D Art

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

0.16mm layer, 2 walls, 35% infill

Designer

1.4 h

1 plate

4.5(14)

0.16mm layer, 2 walls, 35% infill

1.4 h

1 plate

Boost

128

284

325

114

Released

Description

I have prepared a collection of coasters from the world of Harry Potter for you. The collection consists of six coasters and one stand. The diameter of the coasters is 100mm and the height is 4mm. I recommend printing the stand with a collar and supports, without them spaghetti will start to do it. I hope you will like it and I wish you trouble-free printing

For a nicer look of the coaster, I recommend printing with the picture to the pad

Coasters printed on a layer of 0.16 with a 35% fill

Stand printed on layer 0.12 with 35% fill + support

The whole collection of coasters can be found in Raw Model Files. (Download or Print/Download STL)

Have a nice rest of the day

Comment & Rating (21)

@Bville3dprints

Print Profile

0.16mm layer, 2 walls, 35% infill

it didn't need a brim and I was shocked it wasn't the whole collection available to print as shown in main picture

The designer has replied

@Haba97

The entire collection shown in the picture is in the Raw Model Files tab, just take a look. I have the edge there just to be sure, because a few coasters have already lifted off the mat.

@wodan_timmerwer

beutiful

The designer has replied

@Haba97

Thanks

@Ryanjgreen

Print Profile

0.16mm layer, 2 walls, 35% infill

Good print, used generic black and grey pla, not sure if the brim is really required.

The designer has replied

@Haba97

I'm not sure if it's necessary for everyone, but the coaster started to rise from one side when I was printing. That's why I already set the brim on each coaster. I always quickly deburr it with a knife. Thanks for printing and commenting

@user_4055433983

Print Profile

0.16mm layer, 2 walls, 35% infill

looks fine. printed fine. but using the phone app there is no way to print the rest. was very bummed this was just one of a “set” and not the whole set. I can’t figure out how to access or print the rest of the set on the phone app. would be much better if they were on a few plates set up so I could just print “next plate” instead of in a folder separately. just my 2 cents though. still the one I printed did look nice and was a nice thickness.

Other Issues