Electronic Caliper Mount for Pegboard
Copyright Claim
Electronic Caliper Mount for Pegboard
Boost
0
2
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
0
2
2
0
10
13
Released
Description
Pegboard mount for electronic calipers. This accommodates for pegboards with 1-inch spaced holes. Supports needed. Tested with PLA only.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Very good fit for the calipers, the curved peg didn't extend outwards quite enough to be able to push into my board, but I think it's because mine is particle board rather than steel.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Would work as intended just wrong size pegs for my use
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld