Kissing Lips Lightbox

Copyright Claim

Kissing Lips Lightbox

Boost
23
32
5

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
3.3 h
2 plates
5.0(4)

Boost
23
32
5
0
38
25
Released

Description

This lightbox with the look of some nice kissing lips can be easily assembled without any glue or tools!

It is designed to snap together in place and provides even mounting brackets for the LED strip and cable.

 

This is the LED strip I used but I'm sure other similar LED strips will fit too (you will need about 0.5m of LEDs):

https://amzn.eu/d/06IKclh

Now let's assemble it!

First put the LED strip through the hole from the back to the inside.

 

 

Push it all the way through until the beginning of the cable sheath lies next to the cable bracket as shown. It can be a little tight, so please be gentle.

Now put the LED strip into the brackets as shown here.

Cut off the overhang at one of the cutting marks on the LED strip.

 

Tighten the cable to the bracket as shown.

You can use a zip tie or some wire from the packaging when you don't have zip ties laying around.

 

Now it should look like this. This is the perfect time to check the lights before putting it together.

It's time to put it all together!

I found it easier to fit one of the edges first and make my way to the other side but without pushing the two parts together completely.

Before pushing it all the way together, make sure that everything fits nicely!

Now push it together and you should hear the brackets snapping into place.

 

You're done!

Have fun and don't forget to leave some pictures or a comment.

Comment & Rating (5)

Please fill in your opinion
(0/5000)

hey I like this print! any chance you can make it just the lips as 1 solid piece like a logo? i'd prefer to just display it, not use it as a lightbox! thank you :>
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more