Search models, users, collections, and posts
Hangboard
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 6 walls, 30% infill
Designer
37 h
4 plates
0.2mm layer, 6 walls, 30% infill
37 h
4 plates
Open in Bambu Studio
Boost
313
878
26
23
569
155
Released
Description
Climbing hang board, lower half based of the beastmaker 2000 with the upper half featuring easier jugs to holds.
Printed with 6 walls and 30% infil for maximum strength, this will use a lot of filament to make so you might want to use a cheaper filament or do what I did and use up some rolls without much left on them. It holds me fine and I'm a big guys at 110Kg. Holes sized for 14g screws.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (26)