Headphone Stand
Copyright Claim
Headphone Stand
Boost
111
157
47
Print Profile(3)
High quality: 0.09mm layer, 2 walls, 15% infill
Designer
6.8 h
1 plate
Faster print: 0.2mm layer, 2 walls, 15% infill
Designer
4 h
1 plate
Moderate quality: 0.13mm layer, 2 walls, 15% infill
Designer
5.1 h
1 plate
Open in Bambu Studio
Boost
111
157
47
9
506
381
Released
Description
A desktop headphone stand inspired by the design by MakerBot: https://www.thingiverse.com/thing:2050885
I didn't like the orientation it was meant to be printed in so I remade this headphone stand from scratch while keeping the general design looking similar to MakerBot's. This can be printed with minimal support, I just left tree (auto) on to make sure the underside between the two pillars didn't droop.
Comment & Rating (47)
All
Boosted
Print Profile
High quality: 0.09mm layer, 2 walls, 15% infill
Take it easy
0
Reply
Print Profile
High quality: 0.09mm layer, 2 walls, 15% infill
Macht das was es soll.
0
Reply
Boosted
Print Profile
High quality: 0.09mm layer, 2 walls, 15% infill
Printed in petg cf
0
Reply
Print Profile
Faster print: 0.2mm layer, 2 walls, 15% infill
Prints beautifully. Thanks!
0
Reply
Print Profile
High quality: 0.09mm layer, 2 walls, 15% infill
passt perfekt. funktioniert ohne support. danke :)
0
Reply
Print Profile
Faster print: 0.2mm layer, 2 walls, 15% infill
printed perfect, with support.
0
Reply
⭐️ sa serre a rien sa se casse
0
Reply
Print Profile
High quality: 0.09mm layer, 2 walls, 15% infill
works good
0
Reply
Print Profile
High quality: 0.09mm layer, 2 walls, 15% infill
minimalist
0
Reply
Print Profile
Faster print: 0.2mm layer, 2 walls, 15% infill
works great!
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld