German version below.
Also check my new corner clip version: https://makerworld.com/de/models/128146#profileId-138680
I created some printable labels for Ikea Kallax boxes (Dröna). The plate can be slided into the clip and removed by hand or a gap on the left hand side if too tight. If not fitting you can scale the label, alternatively you can remove a little bit of the label edges with a hand deburrer. Better do a test print before series production, but should be fine for a Bambu printer :)
Print instruction:
Labels should be printed with 0.2 mm layer height. Take care of the orientation, the whide side should be faced down. Without AMS it should be possible to print single color logos with only one manual color swap, but i did not try that.
The clip prints without support. I made a normal version, easy to remove and a tight version to prevent kids removing the clip easily.
I prepared these logos (see pictures):
Folders, filament spools, terminal bricks, car, train, pencil, wood building blocks, book, tools, gamepad, cloths, Snacks, baby, sport, medicine, kitchenware and Pillow/Blanket and bambu logo.
Update 02.02.2024: added Teddy, makeup, tooth brush, music, jewelery, camera/photo, decoration/plant, shoes, cables, board games, movies, handbag
For additional labels just ask or create your own, its quite simpel.
Thats it!
Possible problems:
****** GERMAN ******
Jetzt auch als Corner Clip: https://makerworld.com/de/models/128146#profileId-138680
Ich habe druckbare Schilder inklusive Halterung für Ikea Kallax Boxen (Dröna) entworfen. Die Label können von rechts in den Clip geschoben werden und falls zu fest sitzend mit einem Schraubenzieher von links wieder entfernt werden. Ich empfehle erstmal ein leeres Label zu drucken um den Sitz zu prüfen, sollte aber für Bambu Drucker passen. Alternativ kann man auch mit einem Hand Entgrater die Kanten des Labels einmal leicht abziehen.
Druck Einstellungen:
Die Label sollen mit 0,2 mm (oder weniger) Schichthöhe gedruckt werden. Aufpassen bei der Orientierung, die breitere Seite sollte nach unten zeigen. Vermutlich ist es ohne AMS möglich mit einem manuellen Filament Wechsel einfarbige Logos zu drucken aber das hab ich nicht getestet.
Der Clip kann ohne Support gedruckt werden. Ich habe eine normale Version, welche einfach zu entfernen ist und einen fester sitzenden um zu verhindern dass er von Kindern sofort entfernt wird.
Verfügbare Logos (siehe Bilder):
Ordner, Filament Spulen, Klemmbausteine, Auto, Zug, Stift, Holzbausteine, Buch, Werkzeug, Gamepad, Kleidung, Snacks, Baby, Sport, Medizin, Geschirr und Kissen/Bettdecke und natürlich ein Bambu Lab Logo
Update 02.01.2024: Teddy, Makeup, Zahnbürste, Musik, Schmuk, Kamera/Foto, Dekoration/Pflanze, Schuhe, Kabel, Brettspiele, Filme, Handtaschen hinzugefügt
Für weitere Labels einfach melden oder selbst eins entwerfen, geht ziemlich einfach:
Das wars auch schon!
Mögliche Probleme: