Stack Bins | Workbench | Desk | Stackable

Organize your desk, workbench and other horizontal surfaces!

I have designed a fully printable desk and workbench organizer without supports, available with 18 compartments each.

Main Features:

• Two Base Options
  • Flat Base - Flat mounting on the surface with 1.0-2.0mm VHB tape for a secure hold
  • Stack Base - Has legs to align on top of the Flat Base - put 1.0-2.0mm VHB tape between each stacked base
    • Wall Screw for each Stack Base support M3 and #4 size screws to hold against the wall. 
      • Please stack responsibly
    • You could also put the Stack Base on your desk for an elevated organizer, please secure it responsibly.
• Common Sense Drawers
  • Finger Catch - A little pocket to grab the tray/drawer and pull it out
  • Self Catch - The tray/drawer will stop itself from being pulled out too far
    • The tray/drawer will not fall down, you can open it with one hand and grab what you need
  • Smart Assembly - No tools required to insert the tray/drawer
  • Label Area - Put a lable on each tray/drawer in the designated area, fits 1.0 x 0.25 inch and smaller (26mm x 6mm)
• Professional Design
  • Tolerance Analysis verified by exchanging parts assembly from two separate printers printing two different filaments
    • The drawers fit and slide smoothly printing 2 different filaments in 2 different printers
      • Overture PETG Black
      • Polymaker PETG Dark Gray
      • 2x Bambu Lab A1 Printers
  • Strength maintained using advanced Stress Analysis tools during design
  • Rounded corners everywhere aide smooth drawer action
  • Anti-sagging feature when pulled out fully
  • 250-260g (PETG quoted) filament per Base
  • Less than 12 hour printing time per Base
  • 26g (PETG quoted) filament per tray/drawer
  • About 1 hour printing time per drawer
  • NO support
    • NO overhang
  • NO brim (please maintain the constant ambient temperature to prevent warpage)
    • Print in PLA if you cannot handle PETG
    • NO cleanup
    • NO deburring