Camera Cover for PCs, Laptops and Phones

Searching for something to keep your privacy?

This is a camera cover, printed flat. It was redesigned from my previous project to fit any computer, laptop or even cell phones without the use of a hair dryer.

It uses the same mechanism of bracelets, so you can use the same cover in different devices - it is just a matter of matching the proper device curvature.

After the 3D print is done, some handwork will be needed to trim the links - use a micro cutter for 3D printings to achieve better results. Other than that, the process is very straight forward.

You will notice that you will need a little (a little!) strength to bend the links when adjusting to your device - the clearance is tight to not allow the pieces move too easily.

It was printed in PLA but you can try other materials if you wish. It can be dimensioned to be used for other purposes as well.

Did it work for you? Post a photo here!

As usual, enjoy it!