Wolf_Art_2D
Wolf_Art_2D
Boost
134
203
52
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
134
203
52
1
494
229
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PETG JAYO Black Transmission Distance: 0.3
PLA Protopasta White Transmission Distance: 21
Swap Instructions:
Start with Black
At layer #9 (0.48mm) swap to White for the rest.
Comment & Rating (52)
All
In your instructions you say to swap to white at layer #9 (.48mm). With the first layer .16mm and the rest .08mm, layer #9 is .8mm, and layer #5 is .48mm.
The designer has replied
1
Reply
yes, I know, I think I made a mistake, it's how it is in the slicer, I'll change it
0
Reply
Replying to @Wall_Art_3D
This turned out awesome! This was done with color change at layer #5 (.48mm). Thanks so much for this little work of art. I'm going to put some magnetic tape on the back side of it and use it as a refrigerator magnet.
1
Reply
Replying to @Wall_Art_3D
This one is even better! I set the swap to white at layer #4 (.4mm), this is amazing! Thanks again for this model!
2
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
wow - so great
The designer has replied
1
Reply
Thanks guys 👍
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Beautiful!
2
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
I added some grey in between the white and black and it turned out even better. First profile was nice though.
2
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Came out really nice! Good job!
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
made bi-color with black and cold White, fkin love It thank.you!!!!!!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Really good printing, I used jayo black and white PETG and finally removed two hairs and that was it, super good!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
It would be better to make the color more subtle and add bronze.
The designer has replied
1
Reply
ok
0
Reply
I just got your wolf model and it is stunning! Did you create all of your models? Great job! Is it acceptable for us to sell 3D prints of your work? Is there any way that we can give you a tip?
The designer has replied
0
Reply
hello , yes did you can send me private messages
0
Reply
License
This user content is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld