Star Wars Neon Sign by thingspatprinted

thingspatprinted

Art>Signs & Logos

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

22.7 h

8 plates

4.8(5)

Boost

187

302

221

107

Released

Description

Build difficulty: Moderate

These are STL files used to create the 3D printed Star Wars Neon LED sign. Entire model is around 11 inches tall and 2 feet wide. Other materials used to build are listed below. I printed in multiple pieces and used a soldering iron to weld the pieces together.

Neon LED strips (Total length of lights is around 15.6 Ft so 1 roll should be enough):

https://www.amazon.com/dp/B08SJ6DSZR?ref=ppx_yo2ov_dt_b_product_details&th=1

12 volt Power supply (I have tested and both 1 amp and 2 amp power supplies work on the sign I built):

1 amp

https://www.amazon.com/dp/B00FEOB4EI?psc=1&ref=ppx_yo2ov_dt_b_product_details

2 amp

https://www.amazon.com/gp/product/B077PW5JC3/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Cable to attach end of Neon LED strip to on/off switch:

https://www.amazon.com/dp/B01GPQZ4EE?psc=1&ref=ppx_yo2ov_dt_b_product_details

On/Off Switch:

https://www.amazon.com/dp/B0895NVJLF?psc=1&ref=ppx_yo2ov_dt_b_product_details

Optional, instead of on/off a dimmable switch can be used:

https://www.amazon.com/gp/product/B07KW4NCCJ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Comment & Rating (10)

@photosbyd386

Print Profile

0.2mm layer, 2 walls, 15% infill

great

(Edited)

The designer has replied

@thingspatprinte

nice work! love the battle droid

@DarthRevan5963

How do you get the neon strip in multiple places? Do you travel the strip under the sign to get to different places on the sign or something? I have zero experience with neon signs!

The designer has replied

@thingspatprinte

great question. the back of the neon strip has black lines where you can cut it. you cut into sections to fit into the printed frame and then you solder wires to connect the strips, hiding the wires on the back of the sign

@DarthRevan5963

Thank you so much! That helped a lot!

@MarcoDra

Print Profile

0.2mm layer, 2 walls, 15% infill

well... this Is super cool! never tried before thiis kind of "neon"... very cool!!! Just few Curves are a Little bit too ( Little difficult to put the neon strip inside and bending) but i understand this was for have the item not too big ( and this have a food dimension) A+!

The designer has replied

@thingspatprinte

thanks for the comment. yes it is a tough balance to keep it a manageable size overall and keep everything in proportion. I hope you are able to complete it and let me know if you have questions