This is a remix of Helichrissi's Mavic Air 2 phone holder design. My goal for this remix was to make the holder a little more sturdy by adding more screws. I also wanted to create one that was slightly larger to accommodate my phone with an Otterbox case. I added four screws to attach the lower part of the holder to the base and also added a center screw to attach a clamp to keep the base from slipping off the controller. Finally, I designed a thumbscrew to allow for toolless assembly and disassembly of the mount.
Printer Brand: Creality
Printer: CR10S PRO
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.2
Infill: 30%
Filament: Hatchbox PLA Grey
Notes:
I used rafts because I was getting some warping on the larger parts; however, they may not be required if you have a different setup.
Category: R/C Vehicles