Spiral Trophy
Copyright Claim
Spiral Trophy
Boost
25
43
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Open in Bambu Studio
Boost
25
43
9
0
44
45
Released
Description
Spiral Trophy (no supports,nice test for the printer)
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
not perfect but good
1
Reply
Buen modelo, funciona sin soportes y lo imprimí un poco mas pequeño todo ok !! le agregue una pequeña bolita en la parte superior como el #1 ;)
1
Reply
Do you think it will scale up?
The designer has replied
1
Reply
Yes, for example, I shrunk it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The free floating spiral is hard to print without supports since it is not attached to anything. With supports, it is hard to get supports off without breaking the spiral. Nice idea but hard to get a good print. I would like just the piece without the spiral. UPDATE: perhaps you should share any specific parameters to change to succeed in the print.
(Edited)The designer has replied
0
Reply
https://vm.tiktok.com/ZGe5a8PVE/
if the printer is set correctly it works fine
0
Reply
very cool but the vibration of my bambu a1 caused some blemishes on one of the arms towards the top. At the top of the print the unsupported arm shakes a lot.
The designer has replied
0
Reply
it's a good challenge
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld