Finger Skateboard
Copyright Claim
Finger Skateboard
Boost
8
12
14
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
28 min
1 plate
Open in Bambu Studio
Boost
8
12
14
0
56
38
Released
Description
Recommended redrill holes with 3mm drill bit.
Need for assembly:
2x M3x20 metric screw
2x M3 nut
4x M3 washer (between wheel and hub)
Comment & Rating (14)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Nice Print! Heated the tips and bent them up a bit give it a little more kick! Assembly is good. Holes are perfectly sized for M3 hardware. Used locknuts as suggested, zero issues. Thanks!
(Edited)
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Rollen aus PLA und das Deck aus PETG
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
hi, can you tell me what was the issue for low number of stars?
0
Reply
thair was no pol to pit together
0
Reply
not the best for moving
0
Reply
terrible design, the nuts just fall out, this doesn't work
The designer has replied
0
Reply
Please use lock nut (DIN 985) or threadlocker (Loctite 243) to prevent losing nut.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
prints perfectly and you can even use a small bit of unprinted filament and a lighter/;solder to melt the ends flat and create axels for the wheels without any extra parts!
1
Reply
er Super
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld