Big Brick 500% (5:1) - Body with Tie

This Big Brick figure Body with Tie and Suspenders fits the 5:1 versions of Mega Brick (10:1 scale) by Julia Ebert.

The print is setup to minimise AMS waste by printing the coloured parts separately. These will snap into place but best to be glued.

Colours Used:

Body:

Red

Tie and Suspenders

Grey

Black

Army Beige

Notes:

1. This is the 500% 5:1 version. See here for 5:1 500% version.
2. No supports required
3. Align the front and back prints on the body and glue
4. The button is a little tricky, but it will align with patience. Make sure to glue. I may improve this in v2 in the future.

I have separated each part of the Big Brick figure into modules, just like the original building blocks this gives you the freedom to create your own design.  This also makes it easy to make any improvements to the modules as I will only need to update each module. You can get the rest of the Big Brick figure from each section below:

Head: Big Brick 500% (5:1) - Heads | Collection

Body: Big Brick 500% (5:1) - Bodies | Collection

Arms and Hands: Big Brick 500% (5:1) - Arms | Collection

Hips: Big Brick 500% (5:1) - Hips | Collection

Legs: Big Brick 500% (5:1) - Legs | Collection

Accessories:  Big Brick 500% (5:1) - Extras | Collection

See my other 500% 5:1 Big Brick 3D prints available here: Big Brick 500% (5:1) | Collection

See my other 1000% 10:1 Mega Brick 3D prints available here: Mega Brick 1000% (10:1) | Collection

See my other models here.

Don't forget to leave ratings with photos. Thanks!