Hexagonal Lamp

Hardware

• The bulb is an LED. I would avoid bulbs that get hot.
• Switch
  • 2x 20mm M3
• Lamp Posts
  • 6x 12mm M3
• Socket screw
  • There is a separate hole for the lightbulb socket for a screw to go in, that i used to prevent the socket from falling out or spinning around.
• Lightbulb socket
  • I cut off the spinning part of the socket that turns on the light and soldered my own switch in the power line

Print Info

• The posts were printed laying horizontally
• You can print a 159x54x1.8 mm flat square and remove top layers to do infill patterns if you'd like. I tested with honeycomb but my wife didn't like it
• The diffuser is flexible enough to get into the slots without too much trouble
• I printed with 0.2mm layer lines
• (Optionally). I also put air dry clay inside the base to make it feel heavy.

I've shared .step files so you can easily modify at will. Thanks for looking.