Polymaker/Duramic AMS ring with 2 tabs
Remixed by
Copyright Claim
Polymaker/Duramic AMS ring with 2 tabs
Remixed by
Boost
9
16
11
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
9
16
11
0
38
77
Released
Description
I was using JamKo76's Polymaker rings, but the nub/tab was always hard to push in, and the rings were a little too thick to roll smoothly in my AMS. So I trimmed 0.4mm from the base of the ring to make it fit better without affecting the part that clips onto the cardboard spool. I also changed the nub/tab a little, made it smaller (my Polymaker spool's hole measures 4.1mm, so I made the nub 3.8mm).
PS: These rings work great for Duramic spools too!
Let me know how it works for you!
Printing instructions
Set infills all to concentric, and on the X1C, it's a sub 10 min print.
Comment & Rating (11)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Nice profile, smooth print.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Fits perfectly, and holds well
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Really quick print and fits perfectly.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfect fit for Duramic PLA+ and Basic spools.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
This worked well for my Polymaker spool, but I did have to punch a new hole in the cardboard to accommodate the tabs on the print.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
good, solid
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld