Who needs Ridge! 😉

This is a remix/remake of the Cascade Card Wallet with an insert for an Airtag. The body has been fully recreated with the expanding slots (used to hold the cards in place) moved to the sides.

There is an additional hole on the back to push the Airtag back out. I use the top end of a pencil.

Because of where the hole is positioned, I haven't made a version with a money clip. If I find I need a money clip, I'll make one - but I probably won't feel the need. More remixes welcome! 😁

Instructions

Download the body from here (Airtag_Body_WalletRemix.3mf), then head over to https://www.printables.com/model/261476-assemble-after-print-cascade-card-wallet-remix and download the following:

• Textured_Lever_WalletRemix.stl
• Inner_Fan_WalletRemix.stl
• Back_Button_WalletRemix.stl

Print the body in upright orientation (tree supports recommended, if not required), and the rest of the notes in the above link's Description are still relevant.

One extra note I'd add is that this will likely be a tight fit when you first print it, and the lever will feel rough. That was also the case for me with the original file, so spend some time working the lever back and forth with cards in the wallet to wear down the edges. It will get smoother!

The wallet in the photos was printed in eSUN PLA+ on a Bambu Lab X1C.

• 0.16 layer height
• 15% grid infill
• Tree Supports