Search models, users, collections, and posts
Easter ornament
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
43
88
3
0
34
14
Released
Description
Inspired by others… Made this Easter Bunny Ornament
Swap Instructions:
DO NOT CHANGE ANYTHING. For sure not the height.
You can sell our designs we made and are available on our makerworld page. Wit a small sub on our Patreon you get a commercial license to sell and back our non profit founding for Children with special needs: https://www.patreon.com/wickieprints/posts
Colors used:
Grey
Beige
Black
White
Swap layers at:
Start with Grey
At layer 7 switch to Black
At Layer 14 switch to Beige
At Layer 22 change to white and finish it.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (3)