This is my first model and amateurish REMIX of the Double Coat Hook by TinkrMakr.
I liked the overall design and simplicity of the original hook, but wanted a single hook for use in the bathroom and towels… so I cut it up in Prusaslicer and combined the top- and bottom-most parts.
You will definitely see seams of the merged objects in your slicer, but the model slices just fine.
0.2 - 0.25mm
25% infill should be plenty (Gyroid works well)
3 - 4 Perimeters
(make it as sturdy, or load-bearing, as you need it)
Printable on the side, or on its back… whatever surface finish tickles your fancy.