Edit: Added a Larger Version, check that out here:  https://makerworld.com/en/models/1123228#profileId-1122089 


Hey, First upload..

Let's make some nice unique roses, each one slightly different from the next..

Recommend using a jet flame/ windproof lighter for quickness, a hairdryer should also work.


Start with the base and smallest petals..  (start from the middle and work your way around and out)

Place in and heat the first petal slightly so it's malleable and bend it around itself to form the center of the flower 


Put the second one opposite and do the same, heat until malleable then bend it around the first..


Once you've done those I recommend overlapping them slightly, about a third or quarter petal and go around clockwise or counter clockwise and work your way out until done. 



You could leave it like this or use it with the stem and vase.

I used fuzzy skin on the small vase 


Heat the leaves on the stem and bend them around, I heated it at the top and bent it slightly towards me when the flower is on.
There is some green leaves for around the edge but I don't really use them.

Any suggestions/ comments/ feedback appreciated 

Enjoy, Happy printing.


Used Bambu filaments (except stem)
PLA Basic Red, White, Yellow, Blue, Gold
Matte Black for Vase
Stem is Matte Olive Green from eryone