Marble Corkscrew Gravitrax compatible
Remixed by
Copyright Claim
Marble Corkscrew Gravitrax compatible
Remixed by
Boost
34
91
37
Print Profile(5)
0.2mm layer, 2 walls, 15% infill
Designer
2.5 h
1 plate
uncolored 1pcs 0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
uncolored 0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
2 part Looping 0.2mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Click to see more
Open in Bambu Studio
Boost
34
91
37
0
235
277
Released
Description
Gravitrax compatible marble corkscrew.
Important to have enough Power so the marble comes through! ;)
The 2 rings fit in the holes on the ground (makes it easier to print without supports)
is printable without any supports on P1S and Bambu PLA
i have added a second profile with separated parts
Comment & Rating (37)
All
hi, bei mir druckt der innere Überhang und die Seite nie so gut, hat da jemand Tipps?
The designer has replied
1
Reply
Hi, das kam bei mir auch stark auf das eingesetzte Filament an. wenn es nicht klappt dann Versuch doch mal das getrennte Druckprofil, das muss man zwar kleben, hat bei mir aber bei zickigen Filament geholfen.
BG
0
Reply
ok, Vielen Dank
0
Reply
Print Profile
uncolored 1pcs 0.2mm layer, 2 walls, 15% infill
Nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
lässt sich gut drucken und wunderbar in die Bahn mit integrieren
(Edited)The designer has replied
0
Reply
@TheSonic, hi, danke dir für die Bewertung, welche Befestigungsringe meinst du denn genau? Die beiden 6 eckigen Ringe für die Bodenplatte sind doch in jedem der 4 Profile dabei?
0
Reply
Replying to @Regarnogal
bei mir wurden sie noch angezeigt …. ich schaue nochmal nach
0
Reply
Replying to @TheSonic
@thesonic
Geb bitte nochmal Bescheid. hab grad alle 4 Profile mal geprüft, bei mir sind die Ringe vorhanden 🤔
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
uncolored 1pcs 0.2mm layer, 2 walls, 15% infill
its works!!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Top super funktioniert
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
high speed is required to pass that screw. nice print out :-) thank you
0
Reply
Print Profile
uncolored 0.2mm layer, 2 walls, 15% infill
Printed well, no issues.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bottom side of loop didnt turn out the best but it did work.
0
Reply
Print Profile
uncolored 1pcs 0.2mm layer, 2 walls, 15% infill
My A1 had some issues with the overhang. The part was able to be used but required some sanding. If I were to reprint, I would use the other print profile the designer provided with the top portion separate.
0
Reply
© 2024 MakerWorld