High heel wine holder
Remixed by
High heel wine holder
Remixed by
Boost
54
96
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
9 h
1 plate
Open in Bambu Studio
Boost
54
96
16
2
187
67
Released
Description
High heel wine bottle holder.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
im getting lines inside the shoe and on the back is there a setting im missing
The designer has replied
2
Reply
standart 0.20mm settings,supports enabled. for more standart wine bottles use 110% scale ✌️
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Didn't print nice to be honest. Tried twice, but the raft/support sticks to the model. Also has overhangs.
The designer has replied
0
Reply
tree supports enabled?
0
Reply
Replying to @MemelMagic
Yes I had :(
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great but it is too small for a wine bottle. was I suppose to make larger?
The designer has replied
1
Reply
it very depends on the wine bottle. some fits,others dont. for bigger bottles need to scale it 110-120%.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:lo intente con abs y fallo
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld