Lord of the rings hue forge final
Copyright Claim
Lord of the rings hue forge final
Boost
128
198
65
Print Profile(1)
0.08mm layer, 1 walls, 100% infill
Designer
4.4 h
1 plate
Open in Bambu Studio
Boost
128
198
65
2
320
140
Released
Description
Print at 100% infill with a layer height of 0.013mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Matte Dark Red Transmission Distance: 1.5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 4
Swap Instructions: ( all filaments are from Bambu)
Start with Black
At layer #6 (0.56mm) swap to Dark Red
At layer #7 (0.56mm) swap to Yellow tough
At layer #9 (0.8mm) swap to Jade White for the rest.
Comment & Rating (65)
All
Print Profile
0.08mm layer, 1 walls, 100% infill
Simply amazing! My wife is going to absolutely adore this birthday present :) Thank you so much for the design!!!
(Edited)
The designer has replied
0
Reply
Printed in Sunlu PLA+ white, Sunlu Elite PLA black, Bambu basic PLA yellow, Inland Tough PLA raspberry red
0
Reply
Replying to @marinegeek23
Thank u too for this beautiful review..i appreciate…if u desire to have smth else i ll work on it snd post it for u🫶🏻
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
sieht super aus danke an den Ersteller.
The designer has replied
0
Reply
Danke schoon😎
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
juste parfait merci beaucoup
The designer has replied
0
Reply
Thank u so much i appreciate ❤️
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
très beau rendu
The designer has replied
0
Reply
thanks a lot
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
Bin zufrieden
The designer has replied
0
Reply
Thank u so much
0
Reply
nice
The designer has replied
0
Reply
Did u reply with same colours? Anyway super result🥰
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
Extra project!!!
(Edited)
The designer has replied
0
Reply
Well done❤️
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
Couldnt really see the red in my print, was a bit disappointed my print versus the published photo.
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
The designer has replied
0
Reply
Amazing thank u so much
(Edited)1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
The designer has replied
0
Reply
Perfext🙌🏻
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld