Jigglypuff - Pokemon
Copyright Claim
Jigglypuff - Pokemon
Boost
81
197
32
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
50mm high - 0.2mm layer, 3 walls, 10% infill
55 min
1 plate
𝐀𝟏 𝐌𝐈𝐍𝐈 - 0.2mm layer, 2 walls, 15% infill
2.2 h
1 plate
PLA 0.16mm
2 h
1 plate
Boost
81
197
32
1
435
234
Released
Description
50% scale model
0,2mm layer height
0,2mm Top Z distance
Smoothened Top surfaces
Comment & Rating (32)
All
Print Profile
50mm high - 0.2mm layer, 3 walls, 10% infill
cute print model for my little girl...thank you
1
Reply
Print Profile
PLA 0.16mm
Decent print. thank you.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out really well. smooth but with a tiny bit of stringing. nice print though.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed well but the profile puts supports under the feet and i feel they should not be needed (the feet should just be on the plate, i think it might be a problem of the model). They are both hard to remove completely or to leave on as they came off partially while removing the rest of the supports. The model is really cute!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great only complaint will probably be the support on the bottom was really stuck to the print not as flush as I would like but it’s a great print
0
Reply
Print Profile
50mm high - 0.2mm layer, 3 walls, 10% infill
worked great! even with TPU on SP1!
0
Reply
Print Profile
50mm high - 0.2mm layer, 3 walls, 10% infill
Layers were not very smooth but okay if you're planning to sand.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed out great
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (3)
Click to see more
Related Models
© 2024 MakerWorld