Pie divider

Pie divider

Boost
11
15
1

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 10% infill
0.2mm layer, 3 walls, 10% infill
Designer
1.7 h
1 plate

Open in Bambu Studio
Boost
11
15
1
0
13
2
Released

Description

This is my piedivider for 16pcs.!

You can divide your pie in 16 evenly pieces. This way the pieces will look like from the bakery! Plus, there will be no argument because the sibling's piece is larger :-)

 

Very easy print!

Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For best build plate adhesion, i use a strong hairspray. Apply a thin, even coat of it. I repeat the cleaning and reapplying of hairspray every 5-6 prints.

Comment & Rating (1)

Please fill in your opinion
(0/5000)

lol... Du hast 1:1 genau mein Design genommen, lediglich die Griff geändert und stellst es hier rein als ob du es dir ausgedacht hättest... Ich geh deswegen nicht durch die Decke, kein Problem, es ist ja nicht so, dass du jetzt 100te Downloads hast deswegen. Es wäre allerdings cool wenn du dich künftig an den Kodex hältst und die Lizenzen beachtest. Mein Model darf remixed werden. Allerdings steht auch dabei: Attribution — You must give appropriate credit , provide a link to the license, and indicate if changes were made . You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. Bitte halte dich an sowas, nicht das du deswegen mal echt Stress bekommst. Ansonsten wünsche ich dir weiterhin viel Spaß bei unserem Hobby!
0
Reply
No more