The height of the entire stand is 23 cm

I printed the entire stand with a 0.6 nozzle, except for the logo, which was printed with a 0.25 nozzle
I used M4x20 screws and square nuts.

The parts still need to be glued together to hold the whole thing together.
Printed almost completely without supports, supports are only necessary where there are holes for square nuts and for part 04 which is good to print in portrait.

Parts 08 and 09 are printed in two colors to best match the Plastation 5 console.
I used PETG white and black.

I used duct tape on the top part where the headphones are hung, but it's good to use anything soft or rubbery to prevent the headphones from rubbing.

This smaller model has the option to cover the screws and nuts with covers, I used them in black, but it's up to you what you like.

In the event that someone will print, I will ask for a comment on whether everything was fine or what needs to be improved.

Thank you