Search models, users, collections, and posts
AMS PTFE IN
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 10% infill
Designer
33 min
1 plate
Open in Bambu Studio
Boost
1
3
1
0
1
1
Released
Description
I created this guide for the ptfe because I have the AMS on the side of the printer and it remains lower, consequently the ptfe tube made a couple of bends that I didn't like. This model uses up to 4 6mm x 3mm magnets, I am currently only using 2 and it does not move, in case it vibrates there is the possibility of installing up to 4 magnets. The hole for the magnets is VERY PRECISE, to install them I used a piece of plastic and with a little pressure they entered the seat and no longer move! Made of PETG without supports.
Link to magnets: https://www.amazon.it/dp/B08F7HNG45?ref=ppx_yo2ov_dt_b_product_details&th=1
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)