Snoopy in Puffer Jacket
Snoopy in Puffer Jacket
Boost
19
24
8
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
19
24
8
0
28
25
Released
Description
It's Snoopy in a puffer jacket! A popular design of snoopy now in a magnet form. Simply load the print profile, change colors to suit your style and print!
The Bambu Studio file has two negative cylinders inset on the “jacket” that are sized for 6x3mm magnets. If you have a different size magnet, you can simply rescale them, or if you don't need them, you can delete them entirely!
If you make one, please show me how it turned out! Thanks!!
Comment & Rating (8)
All
Printed on my Ender 3
0
Reply
did not finish properly on our A1. about 60% through it was pulling up from the plate at the edges, and then it dislodged itself and we stopped the print job.
The designer has replied
0
Reply
sounds like a bed adhesion issue! make sure it’s set around 60 degrees and that the bed is clean and oil free! run it under some hot water and dish soap and it should be good as new!
1
Reply
Replying to @ghlavinka4550
thanks, I will try that! I also ready that cold air can cause this kind of result, and we had an open window near the printer.
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
Very cute
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld