Carvings of the Raven and the Midnight Moon - Set of 3 Bookmarks
Carvings of the Raven and the Midnight Moon - Set of 3 Bookmarks
Boost
120
197
22
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
4 h
1 plate
Boost
120
197
22
2
237
109
Released
Description
Carvings of the Raven and the Midnight Moon - Set of 3 Bookmarks
Please share your prints
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Swap Instructions:
Start with Black
At layer #3 (0.32 mm) swap to Dark Grey
At layer #7 (0.64 mm) swap to Light Grey
At layer #9 (0.80 mm) swap to white
Comment & Rating (22)
All
Made this amazing set using black, purple gold and white
3
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
Turned out beautifully!!! I used Sunlu PLA+ Black, Sunlu PLA+ Gray, Amolen Glow in the dark, and Sunlu PLA+ White. Printed on the Cool Plate.
0
Reply
slightly better pic of glow in the dark.
0
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 100% infill
plPrinted well. Wife loves them.
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
Other Issues:The model was super thin
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
A little thin, but printed and released from the build plate properly. I gave these as a gift and the recipient was amazed at the detail and quality of the print.
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
These bookmarks are beautiful, but they’re way too big
0
Reply
way too thin and flimsy to be an actual book mark. but absolutely beautiful
0
Reply
These look nice but they're too big and too thin to be a reliable bookmark.
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld