New York City Lower Manhattan 3D Miniature by jarvizar

jarvizar

Miniatures>Architecture

Print Profile(7)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

Designer Profile (0.16mm layer, Grid infill)

Designer

4.2 h

1 plate

4.9(165)

Printable Frame w/ Water (Optional)

Designer

2 h

2 plates

5.0(99)

"Manhattan NYC" Label (Optional)

Designer

19 min

1 plate

4.9(27)

"New York City" Label (Optional)

Designer

18 min

1 plate

5.0(14)

Click to see more

Open in Bambu Studio

Boost

1222

1833

384

2.5 k

Released

Description

3d miniature of Lower Manhattan, NYC!

Model created in Blender using the Blosm addon.

Check out my collection of other miniature cities: https://makerworld.com/en/u/1935755220/collections/146964

Midtown Manhattan miniature: https://makerworld.com/en/models/495851

Check out my even larger version of Midtown Manhattan including the East River & Hudson River!

Printing & Slicing Details

This model was designed to be printed with a 0.4mm nozzle and 0.16mm layer heights.

Try using a 0.2mm nozzle (0.08mm layer heights) or scaling up for even finer detail!

Note: If roads or other small details disappear after slicing, try lowering the extrusion/line width of external perimeters (outer walls) closer to 0.4mm OR use Arachne walls (can also enable “Detect Thin Walls”).

Framing Details

This model measures almost exactly 6.7in by 4.7in (170.5mm X 119.5mm) and should fit most 5x7 frames (assuming frame lip/overlap is around a quarter inch). Feel free to change the scale/size of the model(s) to meet your needs.

Personally I use these cheap frames from Amazon: https://www.amazon.com/dp/B0C8HY7YSQ

And blue printer paper: https://www.amazon.com/dp/B00006IDQT

I also included a fully printable frame (including a 1mm thick water plate) designed to fit all my miniature cities.

A frame is not required! This model looks great by itself and can be displayed almost anywhere.

See my Patreon for a commercial license, early downloads, polls towards future models, and more!

Comment & Rating (384)

@diabloxx12

comes out great in silver! thank you! keep up the good work!

@diabloxx12

Would love if you made one of all Manhattan that we could print in parts and lay it out together at some point! following you!

@Vinnie

it really does look good in silver! Great job!

@HelpMeDIY

I noticed my bridges look like this one, but the OP's pic shows them suspended... is there a support that needs to be removed to get the suspended bridge and docks?

@Blindman3dland

Print Profile

Designer Profile (0.16mm layer, Grid infill)

Thank you for the amazing print :-) I am completely blind, and back in 2017, I lived for six months in New York City, right by Columbia University. :) can you imagine my excitement when I found a print of lower Manhattan? :-) It was really a pleasure for me to print it out, and try to see whether I could recognize any of the places :-) The print came out perfectly, and I will definitely be printing some of your other prints as well :-)