Bookmark - Horse
Copyright Claim
Bookmark - Horse
Boost
54
85
45
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
54
85
45
3
214
260
Released
Description
Comment & Rating (45)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Quick and easy print. Little bit of stringing which was easily cleaned up. I'm learning how to use my new P1S with AMS so I duplicated the bookmark on the plate and set one to green and one to orange with print sequence by object. Took about 41 minutes with bed leveling and filament swap. My kids are horse nuts and were really excited for these. Thank you, OP!
(Edited)
The designer has replied
0
Reply
Thank you for sharing! Looks amazing. You should try hueforge AMS version if you want to use AMS. https://makerworld.com/models/231188
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfekt
The designer has replied
0
Reply
Nice one! Thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
came out good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great quality print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Love it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
easy print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld