VESA Wall Mount 75 and 100mm
Boost
9
21
8
Print Profile(2)
0.2mm layer, 3 walls, 45% infill
Designer
7.1 h
1 plate
0.2mm layer, 2 walls, 60% infill
10.3 h
1 plate
Open in Bambu Studio
Boost
9
21
8
0
62
30
Released
Description
This is my Wall-Mount for VESA Standart in combination of 75mm and 100mm
Recommended use of PETG or PLA Plus.
The Gap between Wall and Display is 92mm!
Use a 8mm Screw with 80-85mm.
Infill:
45-60%
Update:
08.02.2024: Added a optimized .stl for the Wallmount.
Enjoy, have Fun and Visit or Follow my Profile for more!
Comment & Rating (8)
All
Printed one in PETG for my desk. Works well, but I had to file 1mm off the tip of the *wall* part. It was too long to allow for free rotation of the mount. Perhaps the model could be edited and reuploaded?
(Edited)The designer has replied
0
Reply
have you a picture of that?
0
Reply
1. or 2? If I understand u right I think it’s #1?
0
Reply
Replying to @Calminata
Number #1, I edited my comment for clarity. No photo as the mount is installed, it was quite an ordeal to get the 8mm bolt in haha. But I sanded/filed off 1 millimeter at the tip of the wall mount where it makes contact with the monitor mount.
0
Reply
Print Profile
0.2mm layer, 3 walls, 45% infill
really strong, 34" ultra wide monitor moves smoothly mounted on this
0
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld