festool stand
Copyright Claim
festool stand
Boost
41
100
30
Print Profile(3)
0.2mm layer, 3 walls, 50% infill
Designer
7.3 h
2 plates
0.6mm nozzle, 0.3mm layer, 3 walls, 50% infill
Designer
7 h
2 plates
beta MFT DOG version 0.6mm nozzle, 0.3mm layer, 3 walls, 50% infill
Designer
8.8 h
2 plates
Open in Bambu Studio
Boost
41
100
30
5
112
73
Released
Description
this is a domino 500 stand. it's allow you to work way faster with a maximum of flexibility and accuracy.
it is printed in petg with 0.6 nozzle, 50% infill , 3 walls loop. no support, no brim.
fit tight.
Comment & Rating (30)
All
Dimensions of Mft top. Also note that with the table under it about 4 inches out
(Edited)
The designer has replied
0
Reply
i add a "beta" version in the profil list. if you want to give a try.
you can print first layers, to test if it match.
1
Reply
Replying to @izo0o0
Awesome I am going to print the bottom part out and see what happens.
0
Reply
Replying to @izo0o0
Wow that is so spot on. So cool, I am going to have to print out this one.
0
Reply
MFT table Version :-)
The designer has replied
1
Reply
look like solid
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 50% infill
queda perfecto
0
Reply
Nice, Design. They have ones designed out of wood but never had the time to make one. This is super slick. Only thing that would have been cool is if it would line up with MFT dog holes to allow the use of bench dogs to hold it.
(Edited)The designer has replied
1
Reply
two solutions for that : i make a version with that,but i need some ref to match the standard (i don't have mft dog hole system)
or you can make a wood board with appropriate hole, and screw the stand to it.
1
Reply
This thing is a game changer for small parts. I used it on 12mm drawer sides and it made it so much easier.
The designer has replied
1
Reply
thanks for your comment. yes i dpne this model since i have to deal with small drawer :D.
0
Reply
Perfect print from PETG. Huge savings over purchasing "the dock". Thanks for the upload.
1
Reply
Awesome, good job!
1
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 3 walls, 50% infill
Turned out great in blue PETG... sadly dropped the main unit and two of the top pins snapped off... hazard of the design and them being vertical spirals I guess... DF500 fits flawlessly and still well supported with only 2 pins. Would be great if pins were stronger but not sure you could do that without rotating the print... likely other negatives would be caused by that. So 5-star... but don't drop it...haha.
The designer has replied
0
Reply
I can add holes on the pins, so we can reinforced them with screws
0
Reply
do you have a version for the DF700
The designer has replied
0
Reply
no i have only the df500
0
Reply
Print Profile
0.2mm layer, 3 walls, 50% infill
Easy print, made minor changes to nozzle type and it was great!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld