T-Rex

Copyright Claim

T-Rex

Boost
69
108
13

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.08mm layer, 2 walls, 15% infill
0.08mm layer, 2 walls, 15% infill
Designer
16.7 h
1 plate
3.9(7)

0.08mm layer, 2 walls, 15% infill   Optimized for A1 mini.
0.08mm layer, 2 walls, 15% infill Optimized for A1 mini.
Designer
3.7 h
1 plate

Boost
69
108
13
1
196
107
Released

Description

It's a T-Rex.

 

Comment & Rating (13)

Please fill in your opinion
(0/5000)

Print Profile
0.08mm layer, 2 walls, 15% infill
Easy and excellent print. Only thing that wasn’t perfect was some of the teeth broke off with the supports but I’ve never hear of a dinosaur with perfect teeth
The designer has replied
1
Reply
Now that is funny. Glad you enjoyed the print. 😊
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
I will give it 5*, but I did have an issue with the final support for the tail falling over. It ended up leaving a hole on the underside of the tail, which I filled post processing. Just letting the designer know there could be room for improvement.
The designer has replied
0
Reply
Thank you for your information. I really appreciate any input you have as I am only a learning about 3d printing. It's much easier to do the models in blender and such. Printing is another matter. Thanks again. :)
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Very nice 👍🏼
The designer has replied
0
Reply
Thankyou. Glad you like it. 😊
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Too much supports l, but was ok
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Bed Adhesion Issue:supports failed to adhere to the bed. entire print fell apart.
The designer has replied
0
Reply
Shame to hear you had problems. Many others have printed and enjoyed my print without any problems. I suggest you try using a bit of glue and ensure you plate is cleaned as that will improve your chance of a successful print. Also look into Bambu's help system. Please consider the rating of prints as that not only affects others whom may print and have no problems and choose not to try due to the low rating of a very few. But it also affects the creators standing. Maybe in the future if you have problems instead of rating low and see obviously the high rating of the print that it may not be the print at all but other problems and get further assistance.
0
Reply
@beamr39 Thanks for the helpful Advice. Plate was freshly glued and the plate was clean prior to print. I will re-attempt the print another time and review appropriately.
(Edited)
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thankyou for reviewing. I appreciate your feedback
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Other Issues:The eyes didn't print and the teeth came off with the removal of the supports.
0
Reply
No more